Lugnuts for Revolution wheels

R

RDChaplin

Member
Anyone know where I can get shouldered lugnuts for 4 spoke Revolution wheels. Hole bore in wheel is .625. I have 7/16 studs on my spridget.
 
Had mine bored out to accept regular size shouldered nuts. A lot cheaper and easier to find. But my Revolutions are old.
 
As far as I know, Revolution was supposed to start making the classic 4-spoke wheels again beginning last January. No US distributor that I could find, but Google their English site and see if they have the lug nuts.

James Wiley
#72 HP Midget
 
See my posting back in Oct 11.... search for "Lugnuts from Seven" as topic.

I posted stuff they had in last catalog... including some 7/16... those were for "small" revolution holes (.625...like you sought). I find that I have 2 hole sizes across my collection of Revolution wheels... early ones are just a tad smaller than later ones, best I can reason... later ones can use either Minilite lug nuts or Revolutions... early ones, the Minilites are too big, od, to work... You can always get the 3/8 thrds. and redrill for bigger studs...

I'm a bit like Sorenson... I never found a "need" for big studs and hassle with holes in everything else..., have seen "skinny" walled ones part in two, why do it? More likely to break a spindle and loose everything.... But, I also run with what is on the car I have at the time...... if "upgraded" no reason to go back, either...

Just go back and see earlier post, or call Seven...

Bob L.
 
The car came with 7/16 studs and had aluminum slots. Those take shouldered lug nuts but they are 3/4 bore/ sleeve diameter. I bought the Revolutions from a fellow racer. I am going to have the wheels machined for larger diameter sleeve nuts; 11/16. Thanks, for the replies.
 
Thanks to all. Tom came through for me, he had a set of lugs nuts. I have about 2 inches of threaded lug so something else is going to break before there lug bolt or nut. 8)
 
You must log in or register to reply here.
Back
Top