1st Gen RX7/EP parts

Bill Meyer

Bill Meyer

Well-known member
Broken Mazdatrix 13B. x-Bob Neal. Needs rear Iron {one ported & one stock included]. Don't know if rotor, housing or center iron are damaged. Needs disassembly to be sure. Used center iron & 2 good Renesis rotor housings included. No WP or pulleys. $3,500

Tired Jesse Prather 12A. Built with all new irons, rotors & housings. 188 HP @ rear wheels on Jesse's chassis dyno. about 2000 miles. with water pump, Crank & WP pulleys. Was using oil & loosing power so it needs a refresh. Ideally, per Jesse, ceramic rotor tip seals would get another 10 hp. $2,000

Racing Beat 12A intake Matched to 12A above $250

Really light steel flywheel & 7.25" 2 disc clutch. $1,000 Currently still on the 12A.

2 piece Mazdacomp driveshaft. $500

4:88 with OEM LS, lightened ring gear, REM'd and possibly Cryo'd. $850 including ground shipping.

15 x7 Panasports with good Hoosier bias rains $1,200

15 x 7 Light no name aluminum with old hard hand grooved Goodyears. No spacers needed with this set. Light as Circles/Volks. $950

Parts in central Missouri. Shipping additional.

All parts available. Will be noted sold or deleted when gone.

Bill

414-732-773six
 
Bill,

You're not selling any of our ITC chumper spares are you?????????? Don't sell the accusump...........we will need it.
 
All that's left (from the EP car) is listed above...............
But I do have a serious spares package for the IT car!
 
You must log in or register to reply here.
Back
Top