Search results

Hey Bob. Did I miss something? Was there a change in the compression ratio for the 1275?

Thank you Bill, but I found one in Wisconsin.

Okay everybody, it looks like the 21/29 is a rare gear set, so I've done some gear charts perusing and have come up with 22/30 needed for my gearbox. Kerry

The gear in question is still on shaft so it would take a little while to get it off. I'm leaving for long beach tomorrow so a I 'll deal with it when I ge back. Thanks Jon Kerry

Okay, I solved my third gear issue and now I need to replace a pitted 2nd gear. Does anyone have a 21/29 hewland gear for sale? Kerry

Thanks Bill. I had one and it looks like that will suit my needs. But I just noticed that my 2nd gear 21 29 is starting to pit so I might as well replace it now. Do you have a 21 29? Kerry

Do you have a 23 27 Jason? Kerry

I am in need of a hewland dog engagement gear set 24/28 if anybody can help. Kerry Foote

Thanks Bob. Those numbers tell me I'm in the ballpark with the gears I have on hand. Probably be on track in July. Fingers crossed. Take care.

So my 1275LP is just about ready to be installed, but I'm not sure about the ratios that are currently in my dog box. I know that the power band will be wider than my 948 so maybe I should re-gear for a bigger drop between shifts. I guess I'm asking if anybody has any suggestions for gear...

Thanks Rick. I already have a pair of aluminum hubs, but they are for the wire wheel discs so I need a the spacers to modify. It looks like J Becker has a pair for sale. Kerry

If Kendall doesn't buy it I will. I need a spare. Kerry

Definitely intetesred. Please check email. Kerry

Looking for a pair of spacers to install Spitfire rotors on my sprite. Jeff at WC does not have any in the works at this time. Kerry Foote HP Bugeye

What are you LP guys using for fuel?

I need your help. I have a Tilton aluminum flywheel for my 1275 LP engine that's uses a 5.5 inch clutch .The hardened insert for the clutch sets in a recess in the flywheel and is located with the clutch attachment bolts. Does anyone know where I can get a new hardened insert. Kerry

I need your help. I have a Tilton aluminum flywheel for my 1275 LP engine that's uses a 5.5 inch clutch .The hardened insert for the clutch sets in a recess in the flywheel and is located with the clutch attachment bolts. Does anyone know where I can get a new hardened insert. Kerry Foote

Hello all. I just purchased a pair of upgraded spindles from Winners Circle and would like to know if anyone can tell me the Timken bearing numbers to use with these spindles? I understand there may be a difference in the radius on the inner bearing that could cause a problem by not correctly...

I've finally cut out and welded the rear fenders on my HP Sprite so I could lower it more. Measuring at the pinch seam under the rocker my first adjustment has the rear at 2 1/4 and the front at 2inches. I was wondering how this compares to some of the other prod Spridgets out there. Thanks

Can anyone tell me where in the GCR I can find the weight penalties for non stock dampers. I see where the subject of alternate gear engagement is laid out but I cannot find anything about prep 1 suspension with a prep 2 engine. Thank